This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| md:pi-configure [2021/11/04 21:51] – [Adapt the settings in MESHdesk] admin | md:pi-configure [2022/01/14 14:15] (current) – [Introduction] admin | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Raspberry Pi4 Initial Config ====== | ====== Raspberry Pi4 Initial Config ====== | ||
| ===== Introduction ===== | ===== Introduction ===== | ||
| - | * This page will cover the initial configuration of the Raspberry Pi4 running RADIUSdesk | + | * This page will cover the initial configuration of the Raspberry Pi4 running RADIUSdesk. |
| * We assume it is plugged into a network with a Huawei LTE Router. | * We assume it is plugged into a network with a Huawei LTE Router. | ||
| * We will assign a fixed IP Address of 192.168.8.220 to the Raspberry Pi4. | * We will assign a fixed IP Address of 192.168.8.220 to the Raspberry Pi4. | ||
| Line 29: | Line 29: | ||
| {{: | {{: | ||
| + | |||
| + | ==== Adapt Sample Demo1 Mesh ==== | ||
| + | * In a similar way edit the **Captive Portal Exit Point** in the Demo1 Mesh (change the IP Address) | ||
| + | |||
| + | ==== Adapt Sample Demo1 AP Profile ==== | ||
| + | * In a similar way edit the **Captive Portal Exit Point** in the Demo1 Access Point Profile (change the IP Address) | ||
| + | |||
| + | ===== Next Steps ===== | ||
| + | * Congratulations your system is now ready to manage the Access Points. | ||
| + | * There are dedicated Wiki Pages on how to **flash and point** the Access Points to the server. | ||
| + | |||
| + | |||