RADIUSdesk

Trace: › pi-configure

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
md:pi-configure [2021/11/04 21:49] – adminmd:pi-configure [2022/01/14 14:15] (current) – [Introduction] admin
Line 1: Line 1:
 ====== Raspberry Pi4 Initial Config ====== ====== Raspberry Pi4 Initial Config ======
 ===== Introduction ===== ===== Introduction =====
-  * This page will cover the initial configuration of the Raspberry Pi4 running RADIUSdesk Full version.+  * This page will cover the initial configuration of the Raspberry Pi4 running RADIUSdesk.
   * We assume it is plugged into a network with a Huawei LTE Router.   * We assume it is plugged into a network with a Huawei LTE Router.
   * We will assign a fixed IP Address of 192.168.8.220 to the Raspberry Pi4.   * We will assign a fixed IP Address of 192.168.8.220 to the Raspberry Pi4.
   * We will also cover the settings on RADIUSdesk that needs to be adjusted to work with this IP Address.   * We will also cover the settings on RADIUSdesk that needs to be adjusted to work with this IP Address.
  
-===== Set A Fixed IP Address on Pi4 =====+===== Set A Fixed IP Address On Pi4 =====
   * Edit  **/etc/dhcpcd.conf** and make sure the following is specified   * Edit  **/etc/dhcpcd.conf** and make sure the following is specified
 <code bash> <code bash>
Line 21: Line 21:
   * Reboot the Raspberry Pi4 for the new settings to take effect.   * Reboot the Raspberry Pi4 for the new settings to take effect.
  
-===== Adapt the settings in MESHdesk =====+===== Adapt The Settings In MESHdesk =====
   * Use your browser and go to the IP Address of the Raspberry Pi4.   * Use your browser and go to the IP Address of the Raspberry Pi4.
   * Log in. (root / admin)   * Log in. (root / admin)
Line 29: Line 29:
  
 {{:md:initial_settings.png|}} {{:md:initial_settings.png|}}
 +
 +==== Adapt Sample Demo1 Mesh ====
 +  * In a similar way edit the **Captive Portal Exit Point** in the Demo1 Mesh (change the IP Address)
 +
 +==== Adapt Sample Demo1 AP Profile ====
 +  * In a similar way edit the **Captive Portal Exit Point** in the Demo1 Access Point Profile (change the IP Address)
 +
 +===== Next Steps =====
 +  * Congratulations your system is now ready to manage the Access Points.
 +  * There are dedicated Wiki Pages on how to **flash and point** the Access Points to the server.
 +
 +
Last modified: 2021/11/04 21:49